{"id":45969,"date":"2024-06-17T02:00:03","date_gmt":"2024-06-16T23:00:03","guid":{"rendered":"https:\/\/simucube.com\/en-gb\/passive-pedal-setup\/"},"modified":"2024-06-17T02:00:03","modified_gmt":"2024-06-16T23:00:03","slug":"passive-pedal-setup","status":"publish","type":"page","link":"https:\/\/simucube.com\/en-gb\/docs\/activepedal\/software\/passive-pedal-setup\/","title":{"rendered":"Passive pedal setup"},"content":{"rendered":"
Passive pedals can be used with an ActivePedal. To use external pedals connected to ActivePedal they need to be added as a device to Tuner.<\/p>\n
<\/p>\n
To add passive pedal<\/abbr>, press Add device -button found on bottom left corner of the Tuner and select “Passive pedal”. Now a new device is seen on a device panel. The device has not been configured and therefore it shows yellow circle (not configured). Press the passive pedal<\/abbr> on the device panel.<\/p>\n On a passive pedal<\/abbr> configure view select to which port the passive pedal<\/abbr> is connected (1 or 2) and select pedal role: brake, throttle or clutch. <\/p>\n To calibrate the passive pedal<\/abbr>, press the calibrate button. Then fully press the passive pedal<\/abbr> and release it a few times. This way the range of the pedal is recorded. After this is done, press ok. Invert axis if needed.<\/p>\n Then input range slider becomes visible, which allows finer adjustment of dead zones<\/abbr> so that the pedal input stays 0% when the pedal isn’t pressed and also always reaches full 100% input, when pressed. Monitor the indicator above the slider to see that the dead zones<\/abbr> are suitable and then save the configuration.<\/p>\n The normal profile view of the passive pedal<\/abbr> shows the current game input level as large slider. <\/p>\n","protected":false},"excerpt":{"rendered":" Passive pedals can be used with an ActivePedal. To use external pedals connected to ActivePedal they need to be added as a device to Tuner. Adding passive pedal\u00b6 To add passive pedal, press Add device -button found on bottom left corner of the Tuner and select “Passive pedal”. Now a new device is seen on…<\/p>\n","protected":false},"author":5610,"featured_media":0,"parent":45973,"menu_order":0,"comment_status":"closed","ping_status":"open","template":"page-docs.php","meta":{"_acf_changed":false,"footnotes":""},"class_list":["post-45969","page","type-page","status-publish","hentry"],"acf":[],"yoast_head":"\nInitial configuration and calibration\u00b6<\/a><\/h2>\n
Passive pedal input mapping\u00b6<\/a><\/h2>\n
\nBy default the input from the pedal is linearly sent to the game so the sensor value maps 1:1 to the game input. Optionally curve mapping can be enable that will allow creating non-linear mapping to the game.<\/p>\n
\nVertical axis is the input sent to the game and the horizontal axis the linear input from the sensor.<\/p>\n<\/div>\n